Hi,
Calibrating the printer with smartto, z axis and thought I would check the extruder.
1. How do you get the printer to extrude 100 mm of filament?
2. Smartto ver 1.0? did not find settings. Tried ver 1.2? And it loaded some settings. The motor steps were in red 000.000 so I just typed the settings in, saved and it worked.
How can I get the rest of the settings to appear?
Thanks
A30 Calibration.
Re: A30 Calibration.
Hi, you may need to upgrade the firmware or downgrade the firmware for your printer.
you can refer to this:viewtopic.php?f=20&t=60676&p=82222#p82222
Hope to help you.
you can refer to this:viewtopic.php?f=20&t=60676&p=82222#p82222
Hope to help you.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!