Geeetech

Hi, If it is printing for a long time, it is recommended to save the sliced print model into an SD card for printing.
Maybe touching the USB cable may cause this situation or signal interference may cause this situation.
Slice software. You can also try using Repetier Host.

I'm one of those who is getting pausing in prints - i am printing from SD. I am printing the benchy gcode file that came on the microSD card with the A30. I have tried more than 2 other different MicroSD cards.

I am on firmware V1.38.59 and i think Hardware version 2.0null or something. It's a 12V i believe.

I have a capactive touch sensor on it, bought from Geeetech on Amazon, as the bed is very warped. So many high and low spots.

How can i stop it from pausing during the prints?

Hi, have you checked if the heat bed itself is warped,
Regarding pausing printing, it is not recommended,
You can choose to pause printing on the screen.