When the print is paused or filament is run out then the printer stops printing and returns to [0,0] while keeping some Z level. That's OK. Now I put there a new filament. Here are issues:
1) extruder retracts and then it pushes filament slowly so the nozzle is leaking during move
2) return to previous X,Y position is very slow so filament leaks quite a lot while the product is continuing to cool down
3) extruder returns to bad Z level so it pushes down a lot and the filament is leaking all around the product OR it returns to position too high so the filament does not stitch to previous layer
Does not return to correct Z after pause/filament run out and more
Re: Does not return to correct Z after pause/filament run out and more
Hi, does this happens when you print normally?
Has the consumable withdrawal setting been made?
You can try to change it.
Has the consumable withdrawal setting been made?
You can try to change it.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!