Page 1 of 1
Print curling
Posted: Sun Oct 13, 2019 10:18 am
by Chub
Why does the same corner on every print curl recently? Still printing with bed at 55 ?Same when I tried 60 ddeg, Only this corner of the bed. Heat or cold spit of bed? See photos of problem, material and setting
Re: Print curling
Posted: Mon Oct 14, 2019 9:20 am
by William
Hi,You can check if the hot bed is level,
The distance between the nozzle and the hot bed is the distance of a 70gA4 leveling paper;
If the print model is still not sticky, try applying a textured paper to the hot bed.
Re: Print curling
Posted: Sat Oct 19, 2019 9:59 pm
by Jarda3d
hotbed is dirty, it need to be cleaned. And for Superplate use for first layer hgher temp, try 70 or 80°C.