Geeetech

Hi everyone.

Sometime ago I bought an A30 and has been running well until we chose to print with PLA+ black from ESUN. Sadly after the 2-3 layer the nozzle gets clogged. It is weird because with other black spools or with pla's from the same brand but different colour I did not have problems. I tried raising the temperature and playing with the retraction length but no solution. Any of you that may have a recommendation to try? Thanks in advance.

Hi, You can try to clean the nozzle.
Then check the situation and make sure your connection is fully connected.
Appropriately increase the temperature by 5-10° and check the situation.

Hi William. Thank you for the reply. Sadly, I´ve already done that many times. With respect to the temperatures increments, I reached 235° before giving up (I started from 200°).