Filament run-out
Filament run-out
I'm in the middle of a print and using up couple rolls with only little bit of filament left and luckily I went and checked on the print and paused it as the end of the filament was passed the runout and almost thought the extruder wheel... didn't beep or stop when past the run-out switch... anyone else have that problem? What do I need to fix or check to make sure it doesn't happen again?
Re: Filament run-out
Use more turns to tight filament lever in extruder driver.
Did you hear anytime step loss in extruder with clogged tip? I think that no. Like shoot from printer. If not, it is not tighted correctly - except geared drivers like Titan of course, they are like saw already.
Did you hear anytime step loss in extruder with clogged tip? I think that no. Like shoot from printer. If not, it is not tighted correctly - except geared drivers like Titan of course, they are like saw already.
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
Re: Filament run-out
I thought the printer was suppose to pause and beep when the filament end went past the filament run-out...
-
steveski21
- Posts: 17
- Joined: Tue May 31, 2016 6:55 pm
Re: Filament run-out
What kind of a newb do you take me for??.... no, i didn't have it turned on 
hahaha yes I am a newb 
simple question, but a darn good one! THANK YOU Steveski21!!
hahaha yes I am a newb simple question, but a darn good one! THANK YOU Steveski21!!