Hi Gents & Ladies
So I have a A30 which I only purchased in July 2019 and now the Superplate is peeling up off the heatbed
Wondering if many people have had this issue and if so did they replace the Superplate or peel it off and moved on a different way ?
Superplate
Re: Superplate
Hi, Are you referring to the detachment of the glass plate from the aluminum substrate?
May need to replace the glass plate.
May need to replace the glass plate.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
steveski21
- Posts: 17
- Joined: Tue May 31, 2016 6:55 pm
Re: Superplate
front left corner has stopped sticking to the heatbed
Re: Superplate
Hi,If your hot bed is a Mylar sheet plus an aluminum substrate, you can replace the Mylar.
If it is a glass plate with an aluminum substrate, it needs to be replaced as a whole.
If it is a glass plate with an aluminum substrate, it needs to be replaced as a whole.
-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!