A30 Bed level operation in Cura via USB/SD
Posted: Tue Aug 27, 2019 7:21 pm
When printing a file directly from the SD card with the A30 with Sensor, the printer is performing a checkup/leveling of the bed before printing.
It checkes 10 points on the bed.
When printing with Cura over the USB cable, the printer is performing only a short test and is touching only the middle of the bed.
Judging from the print quality, the detailed checkup/leveling with 10 measuring points is needed to ensure good quality
My guess is that Cura needs instructions for the detailed checkup/leveling in the start gcode.
Can we get the correct instructions for the start gcode?
It checkes 10 points on the bed.
When printing with Cura over the USB cable, the printer is performing only a short test and is touching only the middle of the bed.
Judging from the print quality, the detailed checkup/leveling with 10 measuring points is needed to ensure good quality
My guess is that Cura needs instructions for the detailed checkup/leveling in the start gcode.
Can we get the correct instructions for the start gcode?