Re: A30 problem
Posted: Mon Aug 26, 2019 10:12 am
Hi, You can 1. Check if your Teflon tube is fully connected;
2. Heat the nozzle to 200° and manually feed the consumables to see if it can be discharged normally.
Determine if the nozzle is blocked;
3. Check if the Teflon tube has any waste.
I hope this can help you.
2. Heat the nozzle to 200° and manually feed the consumables to see if it can be discharged normally.
Determine if the nozzle is blocked;
3. Check if the Teflon tube has any waste.
I hope this can help you.