Geeetech

I've been battling a problem with my print space. In Cura 4.0, the print fits fine (a 310mm circle). As well it should, it's 10mm under the full size right? Well it does fine all around except the back of the plate. At least a half inch is being ignored. The circle will "flatten" when it gets to that point like it's being limited. Anyone know what causes this? I'm using the cura profile someone posted here recently for 4.0 also. https://scrabblewordfinder.vip https://www.applock.ooo https://www.7zip.vip


And I'm now noticing, the right side of the bed is doing it too, although not quite as badly.

Can you provide pictures of your print?

Mine did too, I first noticed the right side. If I try to push it it wouldn't go all the way to the edge because the wheel nut hit the frame. I turned it around so the nut is on the front and the bolt head easily misses the frame. That still isn't a fix though as the firmware won't allow it to come across or back further. You need Smartto Motor Tool on a Win 10 pc/laptop, then plug it into your printer and change the x and y values for motor travel. I ended changing the X and Y motor travel to 335 and 340 to get it cover the bed.