Geeetech

So my A30 started out great. Good prints, no issues. all was good. Then one day, a problem. Fixed it. Then another. Fixed it, then another. And on down the the line. I'm ready to chuck it.

At any rate, the issue I'm having now, after getting a new hotend installed, is the print just stopping. Everything stays on (bed and hotend temp), but it just stops. At first I figured it was an octoprint issue, as I was getting communication errors. So I tried from the SD card, and same thing. Just stops. I'm suspicious it's the firmware. In the process of all the issues I was having, I also updated the firmware just in case (wish I hadn't). I'm now running 1.39.62 and I'm thinking about rolling back to original if it's easily possible. Unless anyone may have an idea what's going on??

Hi, did the print stop you mean stop printing midway? You can heat the nozzle to 200° and then manually push the consumable to see if it is discharged. For firmware updates you can refer to this:http://www.geeetech.com/forum/viewtopic ... 20&t=68694

I've rolled back to firmware 1.35.56 and this issue has stopped. Doesn't make sense why upgrading firmware would basically render the unit unusable, but I guess they "know what they're doing."