Unsupported Gcode command!
Posted: Sat May 04, 2019 4:13 pm
hi all,
this is my list of currently unsupported Gcode command on A30 firmware that I think are absolutely needed:
M290 (babystepping)
M221 (Extrude factor override percentage)
M303 (PID tuning).
geeetech, at now your printer lacks of the most crucial tuning features.
please, please, please, implement those commands!
or, way way better solution, officially adopt MARLIN 2!
this is my list of currently unsupported Gcode command on A30 firmware that I think are absolutely needed:
M290 (babystepping)
M221 (Extrude factor override percentage)
M303 (PID tuning).
geeetech, at now your printer lacks of the most crucial tuning features.
please, please, please, implement those commands!
or, way way better solution, officially adopt MARLIN 2!