Page 1 of 1
M300 don`t work
Posted: Fri May 03, 2019 12:13 am
by ChrisH90
Hi all, I tried to add a Beep to my G-Code with multiple parameters (M300 S500 P500) but it seems not to work but this G-Code is also part of the valid G-Code list. Did I make a mistake or is this command not implemented yet?
Re: M300 don`t work
Posted: Wed May 15, 2019 6:32 pm
by _kaktus_
Hello.
Have you tried to generate a tone with a higher sound
Re: M300 don`t work
Posted: Mon May 20, 2019 6:27 pm
by ChrisH90
No, I have not. Which frequency works for A30?
Re: M300 don`t work
Posted: Mon May 20, 2019 9:44 pm
by _kaktus_
Hi.
I don't know, but it doesn't prevent from taking the test..
