Geeetech

Do you have any pictures that show how the 3D Touch sensor is to be connected on the new A30? I have been fighting trying to get auto-levelnig working for a couple of months now - and STILL no luck!

Could you give us more details of it?
The hardware version+ firmware version.
You can check the extension board and take photos of it. Maybe it has broken.

As per https://www.geeetech.com/forum/viewtopi ... 20&t=60676

First, you need to check if the "Extruder extension board" is standard.
You need to weld these 5 pins.

This is my bundle of parts now that i have taken off the "printhead"





So now i am looking at getting this installed - my about screen looks like this



I have my soldering iron and solder at the ready - what's next?

Appreciate any help given thanks