Geeetech

I looked through the forum but didn't have any luck with my search.

Anyone know how to turn off the beep and home at the end of a print? I have my end gcode set to home the X axis and move the Y axis so the bed is forward. But after that, the A30 firmware still homes the bed and beeps when it is complete.

I want to turn off the beep and not home the bed. Basically, I want the end gcode to be the end of the program.

Could you tell us your fw version?
You can try to upgrade it to latest version fw.

Firmware 1.37.58
Hardware version 3.2

The beep is reminding you of the print finish.
The Home:
Z-axis raise ;
X axis and Y axis auto home
You can feedback it to :
technical@geeetech.com

Yes, I know what the beep does. I don't need the printer to let me know it is done. Also, homing the bed makes the finished print unreachable.

Is there a way to turn off the beep and the home?

Same problem here, any solutions yet?

Try changing the G-CODE settings in your slider program. In CURE look in SEETING>MACHINE SETTINGS/PRINTER - change END G-CODE and remove "G28"-line as this is the home setting