Page 1 of 1
Anyone want to share their Slic3r Profile?
Posted: Sun Nov 18, 2018 4:12 am
by Sneakers
I was wondering if anyone would like to Share their print settings for Slic3r? I've recently switched to Slic3r from Cura and am curious to see what settings others are printing with.
Thanks!
Re: Anyone want to share their Slic3r Profile?
Posted: Mon Nov 19, 2018 2:35 am
by Lexan
u might take a look in the facebook group, the profiles of AkosW are almost perfekt to start with
Re: Anyone want to share their Slic3r Profile?
Posted: Mon Nov 19, 2018 11:32 am
by Sneakers
Thanks, but I'm not on Facebook. Any chance you could post it here?
Re: Anyone want to share their Slic3r Profile?
Posted: Tue Nov 20, 2018 4:00 am
by Lexan
Re: Anyone want to share their Slic3r Profile?
Posted: Tue Nov 20, 2018 9:39 am
by Sneakers
Thank you so much!!!
Re: Anyone want to share their Slic3r Profile?
Posted: Tue Dec 04, 2018 11:40 am
by advil
Another BIG Thank You for posting that profile link!
Many of us will not touch Facebook and this Slic3r profile is quite good just as it is.
I got a good first print benchie out of it, and the only change I made after that was increasing retract from 6.5mm to 7.5mm and the second benchie was nearly perfect for a .2mm layer print.
Re: Anyone want to share their Slic3r Profile?
Posted: Wed Dec 05, 2018 3:29 am
by Lexan
you're welcome
Re: Anyone want to share their Slic3r Profile?
Posted: Fri Dec 06, 2019 11:39 pm
by Gr1f1S
Hello ,
this profile is also goold for the geeetech A20 ?
Thanks