Good morning.
I have a problem.
My a30 does not complete the gcode file.
Performs all the printing, but when it arrives at the end of the file is not executed part of the code.
For example: perform the end of heating but the unlocking of the motors is not performed.
I tried to update the firmware but nothing.
Someone can suggest where is the problem?
End code not execute
Re: End code not execute
Hello.
Can you show the final part of the code with which there are problems
Can you show the final part of the code with which there are problems
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: End code not execute
in the last firmware there is the bug that when you print via sd card a mashine set end gcode comes after your slicer end gcode and it looks like smartto would ignore your end gcode