Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/

Technical problem with the motor

http://geeetech.net/forum/viewtopic.php?f=65&t=61745

Page 1 of 1

Technical problem with the motor

Posted: Wed Oct 17, 2018 9:19 pm
by bini
Hello,

I post this topic beacause I have a problem with my 3D printer Geeetech A30.
When I want to set home, only one motor for the Z works and the motor turn to go up. So my sensors are down. I have the same problem with the axe Y.
For solve this problem I have try to upload the new software but the problem wasn't solve.

Want can I do ?

Best Regards

Bini

Re: Technical problem with the motor

Posted: Thu Oct 18, 2018 5:41 pm
by Gingko
bini wrote: ↑
Wed Oct 17, 2018 9:19 pm
 Hello,

I post this topic beacause I have a problem with my 3D printer Geeetech A30.
When I want to set home, only one motor for the Z works and the motor turn to go up. So my sensors are down. I have the same problem with the axe Y.
For solve this problem I have try to upload the new software but the problem wasn't solve.

Want can I do ?

Best Regards

Bini
1, Please check if the endstop wire loose or not.
2, One of the Z motor doesn't move, and another one can move(regardless of the direction)?
Swap two motors to see if the error exchange or not.
3, Z and Y motors went to the wrong direction, you can try to change the direction using smartto motor tool, how to get it and use? Check this:
https://github.com/Geeetech3D/Smartto-Tool
All times are UTC+08:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/