Page 1 of 1
Issue Updating Firmware
Posted: Sun Aug 19, 2018 9:35 am
by steveski21
I have has this issue when the A30 will sit in a continual restart loop when connected to a PC
the only way to stop this is to restart the printer
I decided to rerun the Firmware Tool and now I have the below error and it wont let me update the LCD Firmware
Can someone please tell me how to correct this issue
Re: Issue Updating Firmware
Posted: Mon Aug 20, 2018 2:43 pm
by Alex-w
@steveski21
Hi, "max tried" would caused by many reasons. I need more details about it:
1. tool version & firmware version
2. How about upgrading mainboard? Is it normal?
Re: Issue Updating Firmware
Posted: Mon Aug 20, 2018 5:46 pm
by steveski21
Hi alex-w
I worked it out late last night
My issue was I didn't have a SD card in the side of the printer when flashing the firmware
Re: Issue Updating Firmware
Posted: Mon Aug 20, 2018 5:49 pm
by Alex-w
That's great
Re: Issue Updating Firmware
Posted: Sun Jun 07, 2020 3:59 am
by Jmccoy45
steveski21 wrote: ↑Mon Aug 20, 2018 5:46 pm
Hi alex-w
I worked it out late last night
My issue was I didn't have a SD card in the side of the printer when flashing the firmware
Wait what? I don't understand how you fixed this problem. Mine is currently doing the same thing after making the new firmware in Visual Code then uploading the .hex to the printer through Cura. Now any time I connect the USB to the computer the printer will restart, wait like 0.5-10sec, then restart again. This cycle continues till the USB is unplugged and I turn the power supply off. When I turn it back on it works alright and can print files saved to the SD Card.
Help!