Z axis rate issue plus other issues

[macray76]

Thanks all for the confirmation that this is a bug that everyone is experiencing.

@apak - thanks for your suggestion of levelling the other 4 points. My process was a little more complex but got the same result but I'll try your version instead.

I too have a badly scratched super plate but that is mainly down to the auto leveling function not working correctly. I have much better results now going back to manual that I doubt I'll go back to auto leveling even if a firmware update fixes this.

[Miceltu]

...because I had removed the superplate,...

I wonder how? My plate is glued or something like this. I afraid, that i am bend the existing basis alu plate.

Thanks all for the confirmation that this is a bug that everyone is experiencing.
...
I too have a badly scratched super plate but that is mainly down to the auto leveling function not working correctly. I have much better results now going back to manual that I doubt I'll go back to auto leveling even if a firmware update fixes this.

It is a shame. My plate is also scratched.
The Sensor is not good enough working. Manual leveling are working perfekt.
I wonder, what could be the problem, because this kind of technic (AutoBed Leveling) is not new and established.

[William]

...because I had removed the superplate,...

I wonder how? My plate is glued or something like this. I afraid, that i am bend the existing basis alu plate.

Thanks all for the confirmation that this is a bug that everyone is experiencing.
...
I too have a badly scratched super plate but that is mainly down to the auto leveling function not working correctly. I have much better results now going back to manual that I doubt I'll go back to auto leveling even if a firmware update fixes this.

It is a shame. My plate is also scratched.
The Sensor is not good enough working. Manual leveling are working perfekt.
I wonder, what could be the problem, because this kind of technic (AutoBed Leveling) is not new and established.

I think for your heat bed.The mesh level and baby steps is a good solution.But A30 not support right now.