Disappointing
Disappointing
I've got the printer for 2 months now and not a decent print. Each time it continued with printing from any layer with an offset of 3-4mm. The last firmware I installed yesterday (V1.39.62). This also did not improve!
- Attachments
-
- IMG_20181201_083526.jpg (60.24 KiB) Viewed 3984 times
-
- IMG_20181201_083520.jpg (53.36 KiB) Viewed 3984 times
-
- IMG_20181201_083442.jpg (45.79 KiB) Viewed 3984 times
Re: Disappointing
Hello.
This problem is not directly related to the software.
Read about layer shifting in the forum.
And how to solve this problem.
This problem is not directly related to the software.
Read about layer shifting in the forum.
And how to solve this problem.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.