I dont know what the issue here could be, I made my cura settings according to a tutorial, and I am using Geeetech PLA filament.
I attached some photos of 3 prints, each with differend temperatures, can somebody see what the problem could be?
(I thought it might be a clogged nozzle, but would that happen everytime at the same time? I can press filament through a few seconds after I end the print.)
Print fails at layer 1 every time
Print fails at layer 1 every time
- Attachments
-
- IMG_20181022_184105.jpg (518.71 KiB) Viewed 3786 times
-
- IMG_20181022_183454.jpg (299.57 KiB) Viewed 3786 times
-
- IMG_20181022_174627.jpg (264.62 KiB) Viewed 3786 times
-
dogmatic69
- Posts: 11
- Joined: Sat Oct 06, 2018 2:27 am
Re: Print fails at layer 1 every time
Nozzle is too close to the bed, filament cant come out enough to stick. Raise the offset.