Geeetech A30 and Cura

[sasoromih.a@gmail.com]

Hi

my printer connect easily to Simplify3D and EasyPrint but Cura doesn't recognize it. Any suggestions?

[Gingko]

Did Cura show any information?
I find a video about Cura setting for A30, hope it can help you.
https://www.youtube.com/watch?v=TmsUA2rlV2k

[sasoromih.a@gmail.com]

This video is only how to setup profile in Cura. That is not the problem. My problem is that Cura doesn't recognize my printer on any of my two computers.

[_kaktus_]

Can you place a Screenshot with the configuration you have entered?

[Gingko]

This video is only how to setup profile in Cura. That is not the problem. My problem is that Cura doesn't recognize my printer on any of my two computers.

Maybe you can try the old version of cura.

[sasoromih.a@gmail.com]

Thanks. I already did and works.

[GiuseppeScollo]

Thanks. I already did and works.

May I ask you which older version of Cura solved the problem? I got Cura 3.4.1 installed and within a couple of weeks I should receive a Geetech A30 I just ordered. If possible, I should like to know in advance how to solve this problem, if it will occur.

[Gingko]

Thanks. I already did and works.

May I ask you which older version of Cura solved the problem? I got Cura 3.4.1 installed and within a couple of weeks I should receive a Geetech A30 I just ordered. If possible, I should like to know in advance how to solve this problem, if it will occur.

If you also encounter similar problem, try version 15.04.6, baud rate set to 115200.