Right from the beginning I seem to have some trouble with the homing position of my Geeetech A30T.
It came with an already broken air nozzle, and now I cannot find an air nozzle that fits this model of A30T (I bought it in the end of 2020).
Every model I tried to print so far is too short and will melt almost instantly.
I also tried to print a nozzle that goes around the printer nozzle in a circle but, as you can see on the picture, it will be pressed against the hot end by the building plate when homing.
Somehow it looks to me as if the homing position is way too low?
Any help appreciated!
Cheers,
- Homing position of A30T
- 20210117_173000.jpg (175.4 KiB) Viewed 2365 times