Install 3D touch instead of capacitive proximity senso

Ton · Post by **Ton** » Fri Sep 04, 2020 5:43 pm

Hi,

I've been searching the forum to use 3D touch on A30 that has pre installed sensor slot for capacitive sensor but i want to use 3D touch.
Already installed 1.37.58 version of firmware. Also removed the male pins intended for the capacitive sensor and connected the 5 pins accordingly for the 3D touch instead. Take note that i did not use the 3 pin slot. I used the 5 pin slot.

Enabled the 3D touch mode and the auto leveling to let me test the installed 3D touch. But it doesn't work. Please can anyone help me.

Post by **William** » Mon Sep 07, 2020 4:42 pm

Hello, you can check if there is an adapter board interface on your hot end, just connect 3d to the adapter board.

Geeetech

Install 3D touch instead of capacitive proximity senso

Install 3D touch instead of capacitive proximity senso

Re: Install 3D touch instead of capacitive proximity senso