A30T 3D Touch / Proximity Sensor

[blindwilky]

Finally getting this printer to sing, doing some great prints now. It’s been testing to get it there ....
I’m using several beds now but although maybe not needed I’m manually checking the levels so thought I’d by auto sensor.
First issue no firmware for the 3D Touch, so I bought the proximity sensor and guess what can’t find that either.
Has anybody had any joy finding it for the A30T printer...

Had noticed on the video which had been posted on Geeetech website showing setup of the 3D Touch they had it working perfectly, yet I can’t find the firmware !!!!

[William]

Hi，the official website's firmware supports 3Dtouch, you only need to open this function on the screen.

[blindwilky]

Hi William,

Thanks for the reply. Have the 3D Touch working but it only tests the centre of the bed not any other point, what am I missing in the setup ?

[new2geeetech]

I'm looking to a 3d Touch to my A30T but can't find any info on the pinout for the extension board. Can you provide a picture of the ABL wiring at the back of your hotend or direct me to where to find the info? Thanks.

[new2geeetech]

Never mind. I find the info further down the forum list.

[William]

Hi William,

Thanks for the reply. Have the 3D Touch working but it only tests the centre of the bed not any other point, what am I missing in the setup ?

Hi, the start code in the slicer should contain the sequence G28, then G29 for automatic bed leveling.

[blindwilky]

Thanks for your help William,

That worked

[zepeto]

finally got the information zepeto