Page 1 of 1
Firmware for 3DTouch auto bed leveling sensor
Posted: Sun Apr 15, 2018 7:40 am
by eldianel
Hi !
i have buy a Geeetech 3DTouch auto bed leveling sensor
but i need the firmware for my Giantarm D200
for configure this sensor.
Thanks !
Re: Firmware for 3DTouch auto bed leveling sensor
Posted: Thu Apr 26, 2018 3:35 pm
by RolandTruter
I also need to attach a Sensor.
I need the Config.h File of my I3 M201 printer.
Any help would be appreciated.
Re: Firmware for 3DTouch auto bed leveling sensor
Posted: Fri Apr 27, 2018 11:07 pm
by _kaktus_
Roland our printer model (M201) does not work with this sensor.
Re: Firmware for 3DTouch auto bed leveling sensor
Posted: Mon Feb 11, 2019 5:54 am
by fr0gman
The d200 is one of the easiest to level I have ever had. It also holds level quite well. Why would you need auto leveling?
eldianel wrote: ↑Sun Apr 15, 2018 7:40 am
Hi !
i have buy a Geeetech 3DTouch auto bed leveling sensor
but i need the firmware for my Giantarm D200
for configure this sensor.
Thanks !
Re: Firmware for 3DTouch auto bed leveling sensor
Posted: Wed Jul 10, 2019 9:27 am
by Admin
hello,
D200 does not support 3d touch, there is no corresponding firmware.
Re: Firmware for 3DTouch auto bed leveling sensor
Posted: Fri Apr 17, 2020 4:11 pm
by Christin1e
Bi linear bed leveling is when the printer levels the bed itself without you having to manually do it using knobs
tellpopeyes
Re: Firmware for 3DTouch auto bed leveling sensor
Posted: Thu Jul 21, 2022 2:13 am
by reubenkiyan
i have buy a Geeetech 3DTouch auto bed leveling sensor
but i need the firmware for my Giantarm D200
for configure this sensor.