Geeetech

Hi. My e180 used to work with repetier, cura etc but no it only work with Easyprint. When I start repetier I can connect but extruder temp shows 0 and no manual control. It seems that the functionality is degrading until nothing works. Any ideas what cuold be the problem?

Hi, does the printer work when you use Easyprint?
If you mean that when the printer is connected to the slicing software,
the temperature is not correct and can't be moved,
you can check if your serial port is connected correctly.
Whether you need to manually install the driver.

You can refer to this:https://www.geeetech.com/forum/viewtopi ... RlcFtWdCG4

Yes the printer works with Easyprint. Exactly the same happened with my i3 pro b witch only work with Easyprint now. Both used to work with other software.

Hi, You can try to install the driver manually to view it.
Refer to this: https://www.geeetech.com/forum/viewtopi ... RlcFtWdCG4