Geeetech

Hi All
My E180 appears to be coming on in leaps and bounds.
One thing though - I would like to switch over to Slic3r as opposed to EasyPrint.
I believe I have set up my profile correctly, but stand to be corrected.
The problem is that the printer heats up the nozzle nicely - then beeps 3 times, beeps 3 times again and then homes itself as though it's finished printing. Then the firmware seems to go a bit odd and I have to turn off and on again.
Any ideas anyone ? I've attached my profile as it stands

hi, you solved ?

Hello!

My working config for Slic3r-1.3.0.64bit
Configured:
- optimal sticking of the part to the tape
- optimal settings for PLA
- optimal layers and part quality
- optimal print speed (medium)
- fill patter Honeycomb (recommend Rectilinear)

Not included:
Spiral vase - set if you want to print a vase, may require additional layers

Print finished G-code through EasyPrint3D!

This instruction and trial and error method helped me:
https://3deshnik.ru/blogs/vestas/slic3r ... ichja-nora