Page 1 of 1
Changing the nozzle
Posted: Thu Mar 15, 2018 4:57 am
by Heow
Hello,
I don't understand how to change the nozzle (to use the replacement part) on the E180. Is there a special trick to do this? I'm not seeing anything that I can pull/push to release the nozzle.
Pictures would be appreciated :)
Re: Changing the nozzle
Posted: Fri Mar 16, 2018 8:17 pm
by Heow
Hi,
I had an answer from Jocelin from Geeetech, so I'm sharing the pictures with you.
The bit to pull didn't move when using my fingers, so I thought it couldn't move. Using a tool did the trick, I could pull it without problem and remove the nozzle. I didn't need to change the nozzle after all (wasn't cloged or anything) but I wanted to know how to do it...
Re: Changing the nozzle
Posted: Mon Mar 19, 2018 7:15 pm
by William
A more detail:
You should heating the nozzle up to 200C and then remove the filament off
Then you can try it and remove it off
Re: Changing the nozzle
Posted: Tue Jul 30, 2019 2:03 am
by rogerio53
Hello. I cannot pull up the lever. What tool did you use. In case the lever is stuck may I use a bit of W40?