E180 motor problems
Posted: Sat Jan 20, 2018 5:59 am
Hello!
After some successful prints I turned on my E180 today and wanted to check the leveling. But on entering the screen nothing happened, even when tapping the positions.
Then I tried the manual control. X and Y did something, but ended up in an end position with still full engine power (you could hear the hum). When you diabled the engines you could see them "relax" from the end position.
And Z did nothing at all still. The position showed 132mm , although it was all the way up.
Is something wrong with the positioning sensors? Anything I can reset there? Or try out?
Thanks
hmpf
After some successful prints I turned on my E180 today and wanted to check the leveling. But on entering the screen nothing happened, even when tapping the positions.
Then I tried the manual control. X and Y did something, but ended up in an end position with still full engine power (you could hear the hum). When you diabled the engines you could see them "relax" from the end position.
And Z did nothing at all still. The position showed 132mm , although it was all the way up.
Is something wrong with the positioning sensors? Anything I can reset there? Or try out?
Thanks
hmpf