Geeetech

Hello,

I have problem. Heat bed is moving on the side during printing.
Problem is, that there is gap between wheels and profile. Wheels are tightened.
I am exhausted, this product disappointed me.
I want to complaint/reclamation for this product.
Thank you for answer.

https://imgur.com/a/CDl05FE

Hi


You will reveal the secret of what model it is.

A10

Are you unable to invent anything on your own with this defect?
Be creative.

Unfortunately, I do not know this model, because it is new.

Complaints can always be made. And what, now will you be sitting and looking at your printer?
Prove to everyone that you can deal with it on your own

I greet you cordially and wish you faith in your abilities.

check the exentric nuts under the bed