Firmware 3d touch sensor for i3 pro x dual extruder
Posted: Thu May 06, 2021 5:20 pm
Hello,
I would like to know if there is already a firmware download for your printer geeetech i3 pro x dual extruder sensor, and maybe even for the double extruder.
because I can not open the file for editing pin.h pin through arduino ide 1.01.
Thanks look forward to a response.
run 3
I would like to know if there is already a firmware download for your printer geeetech i3 pro x dual extruder sensor, and maybe even for the double extruder.
because I can not open the file for editing pin.h pin through arduino ide 1.01.
Thanks look forward to a response.
run 3