New replacement GTM32 pro board not printing right
Posted: Thu May 06, 2021 3:12 pm
Just received and installed a replacement control board on my M201. Tried printing on it and it starts fine but starts doing its own thing after a couple of minutes. I'm linking videos of the issue. One shows printing from the SD card with gcode from Simplify3D the other is tethered with Geeetech's Easyprint software (latest version .19). I've tried reflashing with the same software.
Fireboy and Watergirl are an exciting series of adventure games developed by Oslo Albet and Jan Villanueva.
Fireboy and Watergirl are an exciting series of adventure games developed by Oslo Albet and Jan Villanueva.