Geeetech is a big disaster
Posted: Tue Jan 28, 2020 12:54 pm
My z-axis is a TR8 not a M8, I found out.
Firmware is not configured for this.
New firmware can't be uploaded, it makes it even worse.
Nozzle is 0,3 mm not 0,4 mm even the mod erator doesn't know.
After 12 months the printer still prints shit!!!
I'll throw it out of the window.
Firmware is not configured for this.
New firmware can't be uploaded, it makes it even worse.
Nozzle is 0,3 mm not 0,4 mm even the mod erator doesn't know.
After 12 months the printer still prints shit!!!
I'll throw it out of the window.