Page 1 of 1
3dTouch problem
Posted: Sat May 13, 2017 4:15 am
by mgros
It is normal, for the pin, to fall due to the vibrations during the infill process?
Any suggestion or help to avoid it?
Thanks in advance.
Mariano.
Re: 3dTouch problem
Posted: Tue May 16, 2017 9:42 am
by William
Hi,could you post some videos to show how do the pin fall due to the vibrations?
Re: 3dTouch problem
Posted: Wed May 17, 2017 4:31 am
by mgros
you can see the accidental deploy at second 9.
https://youtu.be/5Jmm46Bd0LM
The pin fall, touch the bet and not go up.
Thanks for your help.
Re: 3dTouch problem
Posted: Mon May 22, 2017 5:27 pm
by William
mgros wrote:you can see the accidental deploy at second 9.
https://youtu.be/5Jmm46Bd0LM
The pin fall, touch the bet and not go up.
Thanks for your help.
After watching this video,I think it's because the magnet at the top of the probe is short of magnetic force.So here are some tips for you.
1、Change a new probe，especially the magnet inside the sensor;
2、Adjust the screw on the top of the sensor a little higher,like the picture showing.