Geeetech

My 3d printer start printing but it stop taking filament and stop printing. I have revised everything but the extruder keeps failing. Need help.

Does the extruder turn without filiment installed?

Have you tried plugging it into the port for the x or y axis motor to verify that the stepper motor on the extruder is Ok?
What about swapping the motor controller from one of the other motors for the extruders controller?
Have you checked the voltage being sent to the extruder motor?

Hi,there is a post related to your question,and please make the troubleshooting.viewtopic.php?f=19&t=17097. Hope it can help you.

Different components are evolve in 3D printer so that we should learn all the working of their components. Major drawback of uk best essay review is that it is really expensive having cartridge being with it.

See what people are saying on Extruder is not feeding. ... Btw. the stepper didn't feed when I've got my CTC Prusa i3 pro B with GT2650, but it was only ... Another problem I had with that printer was that the bed was much colder than shown in ...
followers italy

I've recently purchased my first 3D printer; a low budget CTC i3 Pro B, which is ... I took the extruder assembly apart and tested the stepper motor separately to see if ... The problem therefore seems to lie within the control board, or the stock ...
buy instagram followers cheap

, Geeetech 3D printer Trouble shooting guide. 2, problem, details ... you need if you are going to upgrade your I3 Pro B to a dual extruder printer ..instagram followers uk