Geeetech

Acrylic Geeetech Prusa I3 pro B 3D Printer

Order NO:20170107145224802 Order Time:2017-01-07 14:52:24

Hello I have 2 problems.
Problem No.1
The Teflon filament guide tube on the extruder is missing. Please send the missing part to me, Thanks
Problem No.2
I assembled the printer, no problem
I aligned the printer, no problem
I did my first print ( the plate as per Geeetek suggested), no problem
While the printer was in stand by mode, I noticed the printer bed was getting hot (very hot) I then turned of the power, and when the bed cooled down. I I then turned the power switch back on and the bed immediately started heating up, I then felt the mosfet and it was very very hot.
could you please send me a replacement board ASAP thanking you.
Bob Slade

Hi,
Why not contact the seller directly?It is so obvious the board needs to be replaced.

Hi thanks for the feedback, I did try that got no reply after 3 emails, this is my 4th attempted to try and get there attention.

Hi,Friend
What address did you send it to?
Contact the sales(zina.luo@geeetech.cn) and enclose your order number.

Thanks for that email address, i have now sent them a letter, hopefully I get a reply

Hello I just wanted to thank you for the infomation you gave me , geeetch are sending me a new board

Best Regarda
Bob Slade

Hi,Bob
Thanks for your updates.It's my pleasure.