Geeetech

Posted: **Mon Jan 30, 2017 4:37 am**

: IMG_4303.JPG (260.33 KiB) Viewed 4829 times

Hello, I received a bad stepper motor with my 3d printer geeetec I3 pro b, board is gt2560. I tried everything, reversing by firmware, swap cables. When i swap stepper motor problem went with it. It will only go one direction. Can you send me a new one, a month of reading on here after i got it together and finally found problem. Need new board.

: IMG_4302.JPG (231.54 KiB) Viewed 4829 times

: IMG_4303.JPG (260.33 KiB) Viewed 4829 times

Posted: **Sat Feb 11, 2017 4:00 pm**

So did you mean the driver board A4988 or the motor itself?
And did you contact your seller?

Geeetech

Bad stepper motor received w/Geeetech p i3 pro

Bad stepper motor received w/Geeetech p i3 pro

Re: Bad stepper motor received w/Geeetech p i3 pro