Bad stepper motor received w/Geeetech p i3 pro

Post Reply
GregKingston
Posts: 3
Joined: Wed Jan 25, 2017 10:54 pm

Bad stepper motor received w/Geeetech p i3 pro

Post by GregKingston » Mon Jan 30, 2017 4:37 am

IMG_4303.JPG
IMG_4303.JPG (260.33 KiB) Viewed 4827 times
Hello, I received a bad stepper motor with my 3d printer geeetec I3 pro b, board is gt2560. I tried everything, reversing by firmware, swap cables. When i swap stepper motor problem went with it. It will only go one direction. Can you send me a new one, a month of reading on here after i got it together and finally found problem. Need new board.
IMG_4302.JPG
IMG_4302.JPG (231.54 KiB) Viewed 4827 times
IMG_4303.JPG
IMG_4303.JPG (260.33 KiB) Viewed 4827 times
Top
bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: Bad stepper motor received w/Geeetech p i3 pro

Post by bang » Sat Feb 11, 2017 4:00 pm

So did you mean the driver board A4988 or the motor itself?
And did you contact your seller?
Top
Post Reply

Return to “Feedback&Suggestion”