Geeetech

= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
Hello,
Bonjour,

You can find the original text into English following this original French text.

Vous trouverez le texte original traduit en anglais à la suite du présent texte originale en français.

Le G-Code M300 pour que la carte contrôleur fasse un bip ne fonctionne pas sur l'imprimante Geeetech Rostock 301 (M300) avec le micrologiciel en version 1.0.02.

Est-ce que vous pourriez m'indique le bon G-code pour que la carte contrôleur GTM32 Pro fasse un bip sur l'imprimante Geeetech Rostock 301 (M300) avec le micrologiciel en version 1.0.02 ?

Merci !

Cordialement,

L'ami René
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Hello,

Excuse me, I am unilingual francophone and I use Google translator to translate the texts of the forum in French and to write to you in English. Thank you for your understanding and your indulgence for these texts translated mechanically!

The G-Code M300 for the controller card to beep will not work on the Geeetech Rostock 301 (M300) printer with firmware version 1.0.02.

Could you tell me the correct G-code for the GTM32 Pro controller card to beep on the Geeetech Rostock 301 (M300) printer with firmware version 1.0.02?

Thank you !

Cordially,

Friend René
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =

Hello William,
Bonjour William,

You can find the original text into English following this original French text.

Vous trouverez le texte original traduit en anglais à la suite du présent texte originale en français.

Est-ce que vous pourriez m'indique le bon G-code pour que la carte contrôleur GTM32 Pro fasse un bip sur l'imprimante Geeetech Rostock 301 (M300) avec le micrologiciel en version 1.0.02 ?

Merci !

Cordialement,

L'ami René
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Hello William,

Excuse me, I am unilingual francophone and I use Google translator to translate the texts of the forum in French and to write to you in English. Thank you for your understanding and your indulgence for these texts translated mechanically!

Could you tell me the correct G-code for the GTM32 Pro controller card to beep on the Geeetech Rostock 301 (M300) printer with firmware version 1.0.02?

Thank you !

Cordially,

Friend René

The engineer said this function(let it beep) is still on the way.