Geeetech

Hi.
I have a problem, the printer is new and I have to press the filament to come out, clean everything and change things, but it still does not come out properly is obstructed continuously, I do not know if it is a firmware or engine problem, also probe in Change the temperature but still the same,

Thanks for solving this problem.

bigtrack wrote:Hi.
I have a problem, the printer is new and I have to press the filament to come out, clean everything and change things, but it still does not come out properly is obstructed continuously, I do not know if it is a firmware or engine problem, also probe in Change the temperature but still the same,

Thanks for solving this problem.

Probably the same problem and solution as discussed in this thread:
http://geeetech.com/forum/viewtopic.php?f=19&t=18010