Geeetech pro B

Post Reply
bigtrack
Posts: 1
Joined: Sun Nov 27, 2016 4:22 am

Geeetech pro B

Post by bigtrack » Sun Nov 27, 2016 4:29 am

Hi.
I have a problem, the printer is new and I have to press the filament to come out, clean everything and change things, but it still does not come out properly is obstructed continuously, I do not know if it is a firmware or engine problem, also probe in Change the temperature but still the same,

Thanks for solving this problem. :oops: :oops:
Top
NiklasO
Posts: 103
Joined: Mon Oct 31, 2016 10:10 pm

Re: Geeetech pro B

Post by NiklasO » Sun Nov 27, 2016 8:11 pm

bigtrack wrote:Hi.
I have a problem, the printer is new and I have to press the filament to come out, clean everything and change things, but it still does not come out properly is obstructed continuously, I do not know if it is a firmware or engine problem, also probe in Change the temperature but still the same,

Thanks for solving this problem. :oops: :oops:
Probably the same problem and solution as discussed in this thread:
http://geeetech.com/forum/viewtopic.php?f=19&t=18010
Top
Post Reply

Return to “Feedback&Suggestion”