Page 1 of 1
SD card not recognized
Posted: Thu Nov 03, 2016 8:49 pm
by mcandrle
I tried to us the SD memory card, formatted one and copied the project. When I plugged it in it did see the card.
Re: SD card not recognized
Posted: Fri Nov 04, 2016 2:34 pm
by William
Hi,
1.You can restart your printer after plugging it.
2.If it still fix it,you can upload the firmware again.
3.If all the above are not working,change another SD card to have a try.
Re: SD card not recognized
Posted: Mon Nov 28, 2016 12:25 am
by mcandrle
I had tried those recommendations. Still not recognized. Firmware 1.1.0 A Need to confirm the correct location I can download the latest from, and the needed instructions.
Re: SD card not recognized
Posted: Mon Nov 28, 2016 2:41 am
by mcandrle
1) I had downloaded Flash_Loader_Demonstrator_V2.6.0
2) Ran the program to upload the bootloader.bin
3) Removed the jumper
4) Ran HyperTerminal
This is where the screen departed from the STM32Pro Firmware burning steps.docx
It appears I am expected to select from a menu, option 1 then option 2 in order to upload the Rostock301_V1.0.02.bin file with the HyperTerminal program. After each attempt, nothing was uploading, so I canceled the operation and pressed the return key and got an OK back from the board.
I can continue to use the unit but can not use the SD card.
Re: SD card not recognized
Posted: Mon Dec 12, 2016 5:49 pm
by William
Re: SD card not recognized
Posted: Thu Dec 15, 2016 3:21 am
by Lami René
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
Hello,
Bonjour,
You will find the original text translated into English following this original French text.
Vous trouverez le texte original traduit en anglais à la suite du présent texte original en français.
Est-ce que votre problème est réglé ?
Si oui, comment avez-vous réglé le problème ?
Est-ce qu’aujourd'hui vous réussissez de belles impressions 3D avec votre imprimante ?
Si vous avez d'autre type de problème, voir des pistes de solution dans le sujet suivant :
http://www.geeetech.com/forum/viewtopic ... 27&t=18578
Cordialement,
L'ami René
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Hello,
Excuse me, I am unilingual francophone and I use Google translator to translate the texts of the forum in French and to write to you in English. Thank you for your understanding and your indulgence for these texts translated mechanically!
Is your problem resolved?
If so, how did you solve the problem?
Are you able to make beautiful 3D prints with your printer today?
If you have any other type of problem, see solution tracks in the following topic:
http://www.geeetech.com/forum/viewtopic ... 27&t=18578
Cordially,
Friend René