Pulleys on g2s pro (or PRO kit)
Posted: Fri Dec 04, 2015 1:20 am
When designing part one thing was forgotten. Other side of bearings all-so has to be supported.
Quick fix for production line would be to include plastic or metal washer that has to be inserted between bearings while assembling pulley.
Better solution would be to move back half of step to previous solution, just different bearing.
In google+ community it was concluded that F624ZZ bearings should be used.
On top of that i can recommend using pin instead of bolts to keep bearing in place.
https://plus.google.com/112050613337136 ... uhjeukxuqE
Regards, Marko
Quick fix for production line would be to include plastic or metal washer that has to be inserted between bearings while assembling pulley.
Better solution would be to move back half of step to previous solution, just different bearing.
In google+ community it was concluded that F624ZZ bearings should be used.
On top of that i can recommend using pin instead of bolts to keep bearing in place.
https://plus.google.com/112050613337136 ... uhjeukxuqE
Regards, Marko