A10M hot end = utter crap. Chimera mount?

[millenium7]

I've had enough of this stupid hot end. I even tried buying another directly from Geeetech, it still constantly clogs and produces crap prints, its just bloody awful and is a nightmare to take apart and clean. Havn't been able to use this printer for ANYTHING since I bought it months ago, it spends all its time on the bench waiting for me to get around to looking and swearing at it again. So I give up entirely, throwing both hot ends in the trash

I have a chinese chimera clone I want to use instead, at least each nozzle has a clear downward path so can be cleaned and installed properly. Problem is I don't have a mount so either I have to design or find one. Does the geeetech carriage share a bolt pattern with any other printer that I could print off a mount for?

[_kaktus_]

Hello.

Remember that what you write here first of all testifies to you.
One of the users wrote:

had mine for going on 5 months runs great 3dprinters are only as good as there operators.

[CalCoop83]

Probably could have gotten to the point with less hostility...