Finally after 3 weeks of calibration i have my print with good quality,
but my printer stuck the print twice either from usb and sd on 49% it did not do anything until was off and on again.
anyone experience the same problem?
any recommendations to solve it?
M201 stuck print on 49%
Re: M201 stuck print on 49%
I think you should use another object to print.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!