Calibration cube print not in the middle - I3 Pro B

[peter1451]

Hi,

Last week I have assembled the Geeeetech Prusa I3 Pro B.
I wanted to print the calibration cube, but the cube was printed not in the middle of the bed.
In x-axis I have 14mm shift and in y-axis I have 1,4mm shift.
How can I solve this issue?
I am using repieter host 1.6.0

Thank you

[bang]

Did you solve it?

[peter1451]

Hi,
I solve it with Repieter, please see below Bed Left and Bed Front parameters.
Here you can set your offset:

Printer settings.jpg (166.46 KiB) Viewed 7513 times

But now I use Cura software and I can't see, where in Cura I can change it.

[bang]

Actually i didn't find the similar setting in Cura