Heated bed not centered

[mogey336]

I'm new in 3d printing i have Geeetech Prusa I3X when i'm printing the shapes are not centered in my heated bed.
I need the slicer configuration please

[Mark]

Hi, Have you set the right settings?

[mogey336]

It's my default setting the heated bed not centered.
I have another problem starts today my heated bed takes almost 1 hour to reach 110 C
When i start printing X motor starts clicking at layer 20 and shifts
any suggestion?

[Mark]

" have another problem starts today my heated bed takes almost 1 hour to reach 110 C
When i start printing X motor starts clicking at layer 20 and shifts"
Have you checked the wires of the hotbed? It could be a bad contact.
And the X motor, whats the speed you use ? maybe is too fast that caused it. and check the belt loose or not.

[mogey336]

this is my configuration settings
The printing not in the center too

[Mark]

Does the nozzle in the lower left of your bed after homing?
If not, you can adjust the two settings "BED Left" " BED Front" to see if it works.

[mogey336]

My homing position is lower left

[mogey336]

My homing position is lower left

[basecircle]

Mark you sent me the info as to setting home pos.I put it all in and when I hit home.It will go not to center but left corner.Do I manually push the axis to where I want home?If so how can I zero it.??? I have the pro 3 b printer.I do not know what i am missing. Help once more. Basecircle

[mogey336]

I have the same problem with my printer Geeetech Prusa I3X
Basecircle