A10M EEPROM

[master2sid2]

Hi. I need some help.
I think I'm reset the EEPROM in my new a10m printer. Now I have a problem with printing, Y-axis offset, stucking bed by home command, uneven first layer. Can anybody make a screenshot from EEPROM of your printer?

[William]

Hi, does the y-axis offset you refer to be layered when printed?
You can try 1. Check the belt tightness;
                  2. Whether the bearing and the pulley are issued (the card can be lubricated for lubrication);
                  3. The printing speed should not be too fast, the reference range is 30-60mm/s;

The hotbed needs to be leveled before printing.

[master2sid2]

I guess that I have found the reason. One of the table wheel bearings is jammed. Thanks for your help.

[William]